Separate Monitoring Time For Stopping The Motor; Enabling Rapid Stop Via Faceplate; Activate Bumpless Changeover To Automatic Mode - Siemens SIMOCODE pro Programming And Operating Manual

Bit = 1: Activated: Tracking of feedback for simulation after the trigger signal and expiration
of the monitoring time (
the monitoring time.
4.1.10.11

Separate monitoring time for stopping the motor

Number of the
Feature
Feature bit purpose
To activate a separate monitoring time for stopping the motor.
The default setting is 0.
Bit = 0: A monitoring time for starting and stopping the motor.
Bit = 1: Separate monitoring time for stopping the motor.
4.1.10.12

Enabling rapid stop via faceplate

Number of the
Feature
Feature bit purpose
Specify if the OS operator can use rapid stop for the block via the standard view of the
faceplate.
The default setting is 0.
Bit = 0: The "Rapid stop" button is not visible in the faceplate.
Bit = 1: The OS operator can use the button for rapid stop.
4.1.10.13

Activate bumpless changeover to automatic mode

Number of the
Feature
Feature bit purpose
To enable the bumpless switchover from local/manual mode to automatic mode.
The default setting is 0.
Bit = 0: Bumpless switchover is disabled. You can switch from local/manual mode to
automatic mode at any time.
Bit = 1: Bumpless switchover from local/manual mode to automatic mode is enabled. A
switchover from local/manual mode to automatic mode is possible if the control settings of
the local/manual mode and automatic modes match. If switchover occurs at a different point
in any time, the "Switchover error" text is indicated on the faceplate.
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
MonTiDynamic
bit: 13
bit: 14
bit: 17
). The feedback signals are generated after expiration of
Description of the blocks
4.1 Functions for all blocks
85