Enabled Operations - Siemens SIMOCODE pro Programming And Operating Manual

Description of the blocks
4.4 Block for MMMeas measured value function
4.4.8

Enabled operations

The operator permissions for control commands are configured in the
parameters. These are transferred to WinCC via the
The operator parameters are controlled via the FBs in CFC.
The activated parameter allows the operator to enter the desired commands.
The operator permissions control operation only in the faceplate.
Table 4- 72
OS_Perm
bit
0
1
2
3
4...20
21
22
23
24...31
OS_PermOut
OS_PermLog
164
Operator permissions – MMMeas
OS_PermOut OS_PermLog
bit bit
0 0
1 1
2 2
3 3
4...20 4...20
21 21
22 22
23 23
24...31 24...31
contains the release information of all parameters.
contains the release based on the current modes.
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
OS_Perm
and
OS_PermOut OS_PermLog
Description
Reserved
1 = Operator is permitted to change to ON
mode
Reserved
1 = Operator is permitted to change to "Out
of service" (Oos) mode
Reserved
1 = Operator is permitted to read data from
the device
1 = Operator is permitted to write at output
AM
1 = Operator is permitted to write at output
AM2
Reserved
SIMOCODE pro PCS 7 Library V9.0
structured
parameters.