Enabled Operations; Faceplate Views; Mmlog - Standard - Siemens SIMOCODE pro Programming And Operating Manual

Description of the blocks
4.6 Block for timestamping MMLog
4.6.10

Enabled operations

The operator permissions for control commands are configured in the
parameters. These are transferred to WinCC via the
The block parameters are controlled via the FBs in CFC.
The activated parameter allows the operator to enter the desired commands.
The operator permissions control operation only in the faceplate.
Table 4- 92
OS_Perm
bit
0
1
2
3
4...20
21
22...31
4.6.11

Faceplate views

4.6.11.1

MMLog - Standard

Standard view
①
②
194
Operator permissions – MMLog
OS_PermOut
bit
0
1
2
3
4...20
21
22...31
Mode display (On, Oos)
Navigation button
Navigation to the connected MM Operation block.
OS_PermOut
OS_PermLog Description
bit
0 Reserved
1 1 = Operator is permitted to change to "ON"
mode
2 Reserved
3 1 = Operator is permitted to change to "Out of
service" (Oos) mode.
4...20 Reserved
21 1 = Operator is permitted to read data from the
device
22...31 Reserved
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
structured
OS_Perm
and parameters.
OS_PermLog
SIMOCODE pro PCS 7 Library V9.0