Self-Test - Siemens SIMOCODE pro Programming And Operating Manual

Description of the blocks
4.3 MMOprtn block
The following parameters are active in the various operating modes of the block:
Table 4- 16
Operating mode Parameter
AUTO
MANUAL
In the Standard view, if the operator permission exists (
1
The self-test command of MANUAL mode tracks the respective command in AUTO mode to ena-
2
ble a bumpless transfer of the command state during mode switchover.
4.3.9

Self-test

The SIMOCODE pro test functions are activated by setting the parameters
The self-test can be triggered by interconnecting the inputs
"Test" button in the operator block. This requires the motor to be in the "Stop" state without a
fault. If the motor is running, the interconnection is ignored and the button in the operator
block is deactivated.
The following parameters are active in the various operating modes of the block:
Table 4- 17
Operating mode Parameter
AUTO
MANUAL
If the operation has been enabled in the Standard view (
1
The self-test command of MANUAL mode tracks the respective command in AUTO mode to ena-
2
ble a bumpless transfer of the command state during mode switchover.
Test phases
Phase 1: Hardware test / lamp test
● The hardware is tested.
● LEDs, indicators and lamp controls are activated.
● Contactor controls remain unchanged.
108
Emergency start
Value
EmrgStAut
1
0
1
1, 2
EmrgStMan
0
Self-test
Value
CstAut
1
0
1
1, 2
CstMan
0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Meaning
Enable emergency start
Disable emergency start
Enable emergency start
Disable emergency start
).
OS_Perm
CstAut / CstMan
Meaning
Enable self-test
Disable self-test
Enable self-test
Disable self-test
).
OS_Perm = 1
SIMOCODE pro PCS 7 Library V9.0
Assigned PIO bits
DP 0.4 = 1
DP 0.4 = 1
.
CstAut / CstMan
, or by using the
Assigned PIO bits
DP 0.3 = 1
DP 0.3 = 1