Message Characteristics - Siemens SIMOCODE pro Programming And Operating Manual

Statistical value
Calculation module 1
Calculation module 2
"X" = Statistical value is available, "–" = Statistical value is not available.
Additional statistical values for PROFINET devices
Table 4- 76
Statistical value
Timer 5 actual value in seconds
Timer 6 actual value in seconds
Counter 5 - Actual value
Counter 6 - Actual value
Calculation module 3
Calculation module 4
Analog MultiplexerOutput
"X" = Statistical value is available, "–" = Statistical value is not available.
4.5.5

Message characteristics

MMStat signals the following errors at the block output:
● Rack fault (
● Module fault (
An error generates a group error
These errors are not signaled as alarms as they are already part of the MMDiag block (both
on the DP master system and behind the Y-Link/ IE-PB-Link). The alarms are output using
the ALARM_8P function.
The messages can be enabled or disabled using the
The alarms are also suppressed if the block is in Out of service mode.
The alarms are suppressed on warm restart for the number of cycles set for power up in the
RunUpCyc
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
SIMOCODE
pro C
Additional statistical values for PROFINET devices
)
RackF_Act
)
ModF_Act
parameter.
4.5 Block for statistical function MMStat
SIMOCODE
pro S
– –
– –
SIMOCODE pro V PROFINET
X
X
X
X
X
X
X
in output parameter
GrpErr
MsgLock
Description of the blocks
SIMOCODE Parameter
pro V
X CalMod1Out
X CalMod2Out
Parameter
Tmr5Act
Tmr6Act
Cnt5Act
Cnt6Act
CalMod3Out
CalMod4Out
AnaMulOut
.
Err_Act
input.
175