Trip Reset; Group Fault - Siemens SIMOCODE pro Programming And Operating Manual

Phase 2: Hardware test result
● If there is a fault,
● If there is no fault:
– The "GEN. FAULT" LED flashes when no main current is flowing.
– The "GEN. FAULT" LED flickers if main current is flowing (in all three phases)
● Contactor controls remain unchanged.
4.3.10

Trip reset

SIMOCODE can be reset with the trip reset command in the following situations:
● The cause of the fault has been eliminated.
● No ON control command is pending.
●
RdytoReset
This resets the process image output PIO DP 0.6.
Reset trip
A trip can be reset as follows:
Table 4- 18
Operating mode Parameter
AUTO /
MANUAL
AUTO /
MANUAL
The command is reset at the end of the execution cycle of the block.
1
If the operation has been enabled in the Standard view (
2
4.3.11

Group fault

The output parameter for group error
detected. The Standard view displays these errors as a group error in plain text.
● General Fault (GenFlt) of the SIMOCODE
● Module Fault
● Rack Fault
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
HW fault basic unit
is generated in the previous APL or at the MMRevDhl block
Trip reset
TrpRstLi
1, 2
TrpRstOp
is triggered.
Value Meaning
1 Trip reset active, trip is reset. DP 0.6 = 1
1 Trip reset active, trip is reset. DP 0.6 = 1
OS_Perm = 1
is set when one of the errors listed below is
GrpErr
Description of the blocks
4.3 MMOprtn block
Assigned PIO bits
).
109