Start-Up Characteristics; Module Error - Siemens SIMOCODE pro Programming And Operating Manual

4.2.5

Start-up characteristics

In OB100, the identifier for "Start up" is entered in output
The alarm messages are suppressed in the OB100 for the
Acknowledge the errors
4.2.6

Module error

Following a restart and when
carried out. The system status list SSL ID xC91 is read out for this purpose. If the module
addressed with
fault" is entered for the
The module fault is detected by the event number 16#61 for PROFIBUS and 16#51 for
PROFINET for event class 16#39.
The module fault is detected while the SIMOCODE pro device is configured behind a Y-Link.
The logical address of the module (
the module, e.g. from
Note
The "module rack fault" takes precedence over the module fault.
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
,
GrpErr RackF_Act
AccId = TRUE
is missing, the
LAddr ModF_Act
output
OMODE (OMODE = 16#40xxxxxx)
LAddr
,
SubN1_Id Rack_No
OMODE
RunUpCyc
, , , and
ModF_Act Rack1Err
, a check of the module addressed with
output is set and the identifier for "higher-level
.
) is derived based on the geographical address of
, , , and
Slot_No SubSlot_No
Description of the blocks
4.2 Diagnostics block MMDiag
( ).
OMODE = 16#xx01xxxx
no. of times.
.
Rack2Err
LAddr
.
SubAddr
is
97