Operator control (hardware)
3.2 Operator controls
3.2.4
RESET button
Layout
The RESET button is located behind the blanking cover on the SIMOTION D410-2.
Figure 3-5
Function
The entire system is reset when the RESET button is pressed and a new power-up of the system
forced.
3.2.5
Switch S5.0
Layout
SIMOTION D410-2 provides the S5.0 switch behind the blanking cover in the lower area of the
front panel.
Figure 3-6
Function
The DIP switch is used for switching the analog input (X131 connector) as voltage or current
input.
Table 3-3
Position
U
I
See also
Interface assignment (Page 58)
44
RESET button
Switch S5.0
S5.0 switch positions
Function
The analog input is used as voltage input.
The analog input is used as current input.
SIMOTION D410-2
Equipment Manual, 07/2021, A5E33446720B