Troubleshooting The Recorder Connection - Philips M3001A Service Manual

Data is missing from a print-
out and the printout is at
lower resolution than normal
Your printout is too big for
the page:
A REMOTE PRINTER
NOT AVAILABLE mes-
sage appears on the screen:
The printout does not appear
at the network printer but
there is no error message at
the Monitor:

Troubleshooting the Recorder Connection

Here is a list of some easily corrected troubleshooting cases. See also page 195, and the
Operator's Manual of the XE-50p Chart Recorder.
Message
You cannot find the record
softkeys.
Troubleshooting the Instrument
a. No longer available.
b. If applicable.
Troubleshooting the Recorder Connection
If printing via a network link—
Make sure that the printer is connected to the
Philips LAN or the M3 Print Server
Connecting a Remote Printer in "Installing the
Instrument").
Make sure that the printer is switched on.
The laser printer was switched off, but the Jet-Eye
was left on. This results in the described
behaviour. Users should be advised always to
switch the printer and Jet-Eye off together.
This can happen if the JetEye is switched on but
the printer is switched off when you start printing.
Make sure both the printer and, if necessary, the
JetEye are switched on, then print again.
Check that the Monitor is connected to the Philips
LAN or the M3 Print Server
If it is not, connect it (see Connecting a Remote
Printer in "Installing the Instrument").
If it is connected, contact the M3 Print Server
b
system administrator .
Check that the network printer is switched on and
not in an error condition.
If it is both switched on and in an error-free
condition, contact the M3 Print Server system
b
administrator.
What To Do
Make sure that the Recorder is configured (see
"Connecting a Local Recorder" on page 96).
a
network (see
a
network.
215