Verification Procedure; Installation Of Wireless Infrastructure; Configuring The Radio Frequency Of The M3/M4 Monitor - Philips M3001A Service Manual

Installation of Wireless Infrastructure

Verification Procedure

Perform the following tests.
Step 1
Step 2
Step 3
NOTE You must document the modification for a particular unit, including the verification tests, in
the CSO. You must add a printed, dated and signed installation note to the Service
documentation of the modified Monitor.
For convenience, we suggest that you attach a label to the instrument next to the output and,
using permanent black or blue ink, add localized text similar to:
"Nurse Call is Open-On-Alarm Relay" or "Nurse Call is open".
Installation of Wireless Infrastructure
See the IntelliVue Clinical Network Service Manual.
Please also consult the configuration section of the monitor's Instructions for Use for
information on assigning a label to the monitor.

Configuring the Radio Frequency of the M3/M4 Monitor

The configuration tool for this procedure is contained on the IntelliVue Information Center
Application Software CD ROM that corresponds to your revision of the monitor and
Information Center, and must be copied to the PC used for the configuration procedure.
The configuring PC must meet the following requirements.
• Microsoft Operating System software (Windows 98 or Windows NT)
• 200 MHz or higher clock speed
• RS 232 serial interface port (9-Pin D type connector)
• contain a CD ROM drive
M3/M4 monitors can have two IP Addresses, one for the monitor itself and one for the
Wireless Adapter card that transmits data to the Access Point. The M3/M4 monitor IP
Address is set dynamically by the Information or Surveillance Center displaying its
monitoring data. This procedure describes how to configure the Wireless Adapter card and
set its IP Address.
78
Power on test (see page 142)
Nursecall Performance test (see page 157)
Safety test (see page 159)
Installing the Instrument