Philips M3001A Service Manual page 129

Step 3
NOTE
The Insertion Tool should be set to cutting mode
removes the insulation at the connection site, clamps the wire in the correct position, and cuts
off the excess wire.
Step 4
Installing the Instrument
Use the Insertion Tool (M3086-43801) to position each wire on the PCB according
the following wiring schematic, where each color corresponds to a number.
Use a small screwdriver to connect the two drain wires to the PCB, see the wiring
schematic above.
MSL Cable Termination
= on. The Insertion Tool automatically
113