Tutorial For Troubleshooting The Instrument - Philips M3001A Service Manual

Tutorial for Troubleshooting the Instrument

Question 1: According to this chapter, what troubleshooting support functions are built-in to
the Instrument?
Question 2: Which of the following support functions display information only (either
operating time or number of cycles for parts or features of the Instrument) and cannot be
modified?
Question 3: There are LEDs available for visual observation during troubleshooting. Where
are they located?
Question 4: Non-fatal error codes are only available in:
Troubleshooting the Instrument
a. The Status Log and error codes are the only built-in troubleshooting support
functions.
b. The Coldstart Test, Display Test, Backlight Test, Reset PumpOpTime, Reset
IRSourceTime, Self-Test Cycles, OpTimeMon, OpTimeMeasS, and NBP Cycles
are the only built-in troubleshooting support functions.
c. The Status Log, error codes, Coldstart Test, Display Test, Backlight Test, Reset
PumpOp Time, Reset IRSourceTime, Self-Test Cycles, OpTimeMon,
OpTimeMeasS, and NBP Cycles are all built-in troubleshooting support
functions.
a. The Self-Test Cycles, OpTimeMon, OpTimeMeasS and NBP Cycles are
selections which display this type of information and cannot be modified.
b. The Coldstart Test, Display Test, Reset PumpOpTime, Reset IRSourceTime and
Backlight Test display this type of information and cannot be modified.
c. The Line Frequency indicator displays this type of information and cannot be
modified.
d. None of the above examples are correct.
a. On the front panel.
b. On the Measurement Server.
c. On the System Board in the M3046A, visible from the rear of the monitor.
d. On the M3046A located on the bottom of the monitor.
e. a. b. and c.
a. Monitoring Mode
b. Configuration Mode
c. Service Mode
d. Operating Mode
Tutorial for Troubleshooting the Instrument
217