Attaching The Measurement Server To A Mount; Detaching The Measurement Server From A Mount; Positioning The Measurement Server On A Clamp Mount - Philips M3001A Service Manual

Attaching the Measurement Server to a Mount

Step 1
Step 2
Step 3

Detaching the Measurement Server from a Mount

Step 1
Step 2

Positioning the Measurement Server on a Clamp Mount

For convenience, if you have your Measurement Server on the clamp mount, you can
position it with any one of the four edges facing upwards (four positions). Reposition it by
completing the following steps:
Installing the Instrument
Make sure the Measurement Server is oriented correctly relative to the mount (see
the picture below).
Place the Measurement Server on the back mount.
If it is not tight against the mount, slip it in the direction of the measurement
connectors until it is.
Slip the Measurement Server forward until it clicks into place.
Latch
Press and hold the latch (in the middle at the top of the mount) away from the
Measurement Server.
Slide the Measurement Server off the mount in the direction of the measurement
connectors.
Attaching the Measurement Server to a Mount
75