Download  Print this page

Disassembly For The Monitor; Removing The Battery; Removing The Power Supply - Philips M3001A Service Manual

M3/m4 monitors,measurement server,measurement server extensions.
Hide thumbs

Advertisement

Disassembly for the Monitor

Removing the Battery

To remove the battery, do the following:
Step 1
Step 2
Step 3

Removing the Power Supply

Read the warnings at the beginning of this chapter.
You must remove the Power Supply to access the fuse.
To remove the Power Supply, do the following:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Repairing the Instrument
Slide the battery compartment door toward the rear of the Monitor, and open it
down.
Locate the battery extractor tape and pull it to disengage the battery socket.
Pull the battery out.
Remove the Measurement Server and, where present, the Measurement Server
Extension.
Remove the battery.
Switch on the Instrument and disconnect the AC power cord from both the
Instrument and the mains power source (after 20 seconds, the capacitors on the
Power Supply board are drained).
Push a thin-bladed screwdriver into the hole next to the cover:
Release the cover.
Remove the two anti-vibration screws. (These are the only anti-vibration screws and
must be refitted. Do not lose these screws.)
Disassembly for the Monitor
221

Advertisement

Table of Contents

   Also See for Philips M3001A

This manual is also suitable for:

M3000aM3046aM3015aM3016a

Comments to this Manuals

Symbols: 0
Latest comments: