Download  Print this page

Removing The Wireless Assembly (for Monitors With Wireless Lan Interface Only); Removing The Lcd Assembly And Backlight Tubes - Philips M3001A Service Manual

M3/m4 monitors,measurement server,measurement server extensions.
Hide thumbs

Advertisement

Disassembly for the Monitor
Step 8
Removing the Wireless Assembly (for Monitors with Wireless
LAN Interface only)
Step 1
Step 2
Step 3
Step 4
Step 5

Removing the LCD Assembly and Backlight Tubes

This procedure describes how to remove the LCD Assembly which includes the LCD screen
and rubber anti-vibration cushion. Once the assembly has been removed, the backlight tubes
can be removed and replaced.
Although you need to remove the chassis, you do not need to remove the System Board or the
Power Supply.
To remove the LCD Assembly, do the following:
Step 1
Step 2
Step 3
226
Withdraw the board from the chassis towards and slightly to the right of you to
avoid hitting the chassis:
Remove the Server as described previously in this chapter.
Remove the battery as described previously in this chapter.
Remove the chassis as described previously in this chapter.
Remove the system board, complete with the wireless LAN assembly, as described
previously in this chapter.
Lift the wireless assembly up to release the connector, then remove the assembly
from the system board.
Remove the chassis as described previously in this chapter.
Use a small screwdriver to remove the Display Assembly cable.
Push the complete assembly (including the rubber cushion, the LCD display, and
the cables) out from the rear of the chassis. Start pushing from the top being careful
not to damage or bend the 6 clips around the cushion:
Repairing the Instrument

Advertisement

Table of Contents

   Also See for Philips M3001A

This manual is also suitable for:

M3000aM3046aM3015aM3016a

Comments to this Manuals

Symbols: 0
Latest comments: