Download  Print this page

Connecting The Measurement Server; With The Measurement Server Directly On The Monitor - Philips M3001A Service Manual

M3/m4 monitors,measurement server,measurement server extensions.
Hide thumbs

Advertisement

Switch the Monitor on using the On-Off/Standby button:
On-Off/Standby
Making the Altitude Setting
A correct altitude setting is important to ensure accurate CO
Step 1
Step 2
Step 3

Connecting the Measurement Server...

...with the Measurement Server directly on the Monitor

You can connect the Measurement Server to the Monitor by mounting it directly on the
Monitor:
Step 1
Installing the Instrument
Enter Config Mode and press the Setup key.
Select Altitude
Select the value from the list which is closest to the altitude of the hospital.
Make sure that your Monitor has a link bar:
Latch
Link Bar
Plug to
Measurement Server
If your Monitor does not have a link bar:
a. Position the link bar as shown in the diagram above.
Make sure that the guide is in the slot under the plug (which connects to the
Measurement Server).
b. Press the Link Bar into position until it clicks.
Connecting the Measurement Server...
Silence
Suspend
Reset
On
Off/Standby
readings.
2
Main
Setup
Screen
AC Power
Battery
71

Advertisement

Table of Contents

   Also See for Philips M3001A

This manual is also suitable for:

M3000aM3046aM3015aM3016a

Comments to this Manuals

Symbols: 0
Latest comments: