Philips M3001A Service Manual page 101

Step 16 Create a log file of the Wireless Bedside configuration.
NOTE The log file is a.txt file that contains the menu dialog of the most recent configuration. Near
the end of this file is a summary of the device's configuration settings. This file may be
viewed in Notepad or printed for later reference.
There are several configuration settings for the M3/M4 monitor that are made by the
configuration tool that are not site specific but are different from factory default settings.
These settings can be seen in the log file, but are not displayed to the user when the tool is
used.
NOTE If a filename is entered for which a configuration file already exists, that file will be
overwritten by the new file.
Step 17 Remove the phono plug from the rear of the Wireless Adapter and replace the cover.
Step 18 If there are additional Wireless M3/M4 Monitors to be configured, repeat Step 1
The Configuration Tool retains the parameter values entered when it was previously run.
NOTE
For each Wireless Adapter configured, enter the parameters for that Wireless Adapter in the
Wireless Bedside Parameters window.
It is possible that all of the Wireless M3/M4 Monitors in a system will have the same
configuration parameters.
When all Wireless M3/M4 Monitors have been configured:
Step 19 Click Close in the upper right corner of the Configuration Tool window.
Troubleshooting
If an error should occur during the configuration process, one of the following
troubleshooting procedures may resolve the problem.
Installing the Instrument
• If you want to create a log file with the Log file name given, click Yes and a log
file containing the text of the menu dialog between the configuring PC and the
Wireless Adapter will be created and stored in the C:\tools\ConfigTool
directory of the configuring computer's hard drive.
• If you want to specify a different filename:
a.click Cancel and a window will open allowing the specification of a different
filename.
b.enter the new filename in the field provided.
c.click Yes to create a logfile with the new filename.
• If you do not want to create a log file, click No to close this window.
Configuration of this Wireless Adapter is now complete.
through Step 12 for each monitor.
Installation of Wireless Infrastructure
85