Refitting The Wireless Assembly; Refitting The Chassis; Refitting The Battery - Philips M3001A Service Manual

NOTE When replacing the Power Supply, make sure it slides into the guide rails provided in the
chassis. Be sure to refit the anti-vibration screws.

Refitting the Wireless Assembly

To refit the wireless assembly, complete the steps for removing the wireless assembly in
reverse.

Refitting the Chassis

To refit the chassis, complete the steps for removing the chassis in reverse. When
reconnecting the Antenna Cable, observe the following:
• Route the free end of the antenna cable through the middle hole (1, below) in the right-hand
column of three holes, as viewed from the back side of the sheet metal:
• Connect the free end of the antenna cable to the connector on the corner of the wireless
LAN board (2, above).

Refitting the Battery

To refit the battery, do the following:
Step 1
Step 2
Step 3
Step 4
Repairing the Instrument
Slide the battery compartment door toward the rear of the Monitor, and open it
down.
While holding the battery extractor tape up and out of the way, insert the battery
with the battery guide-groove facing up and the battery socket towards the inside of
the Monitor.
Push the battery all the way into the compartment making sure the socket is firmly
engaged (the battery can be pushed no further).
Close the battery compartment door.
Refit Procedures for the Monitor
2
1
231