Table of Contents
Advertisement
AUSM Command Reference
The preferred tools to configure, monitor, and control an MGX 8830 or MGX 8850 switch are the
CiscoView and Cisco WAN Manager applications. The command-line interface (CLI) also provides
access to the MGX 8830 or MGX 8850 switches and is highly applicable during initial installation,
troubleshooting, and any situation in which low-level control is useful.
The commands in the tables that follow
Each table shows the complete name of the command and the cards for which the command is valid.
Examples of usage for the more common commands appear in the configuration chapters of this manual.
For information about navigating the command-line interface, refer to the Cisco MGX 8850 (PXM1E)
and MGX 883Cisco MGX 8850 (PXM1E) and MGX 8830 Software Configuration Guide, Release 3.
Tip
If you are viewing this material in a book- or chapter-length PDF file, you can click on any command in
the following tables to link to the description for that command. You can also click on commands listed
in the "Related Commands" sections to link to command descriptions.
Table 4-1
Command
?
aimhelp
clear
clrscrn
cls
Help
myid
setcmdc
setpagemode
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
AUSM Session Management Commands
AUSM-8T1/B
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
C H A P T E R
(Table 4-1
to
Table
4-7) are divided by major functional group.
AUSM-8E1
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
4
4-1
Advertisement
Table of Contents
