Enable The Frsm, Ausm, And Cesm Card Cls And Clr Commands - Cisco MGX 8850 PXM45 Release Notes

System Requirements
Table 16
Table 16
Command
clrspvcnonpers
cnfsvcoverride
cnftrftolerance
cnfuplinkbert
dspsvcoverride
dsptrftolerance
dspuplinkbert
startuplinkbert
stopuplinkbert
Table 17
Table 17
Command
addcon
cnfpnportcc
cnfstatsmgr
dspcon
dspcons
dsppnport
dsppnportcc

Enable the FRSM, AUSM, and CESM Card cls and clr Commands

The FRSM, AUSM, and CESM cls and clr card commands that are supported by the PXM1E card, must
be enabled on the PXM1E card before they can operate on a service module card. Complete the following
steps to enable the cls and clr commands on a PXM1E card:
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
24
lists the new commands for Release 3.0.10.
New Commands for Release 3.0.10
Description
Deletes one or more non-persistent SPVC endpoints from a port.
Specifies three node-level settings that relate to overriding an SVC's or SVP's
ownership of a VPI and VCI (in the case of an SVC).
Specifies a node-level setting to permit the addition of connections whose traffic
parameters may have a slight, unintentional mismatch between the master and
slave endpoints.
Sets up a BERT for a line on the PXM1E UNI/NNI back card.
Displays up to three node-level settings that relate to overriding an SVC's or
SVP's ownership of a VPI and VCI (in the case of an SVC).
Displays a node-level setting to permit the addition of connections whose traffic
parameters may have a slight, unintentional mismatch between the master and
slave endpoints.
Displays the configuration and current status for BERT on a line on the PXM1E
UNI/NNI back card.
Starts a BERT on one of the lines on the PXM1E UNI/NNI back card.
Stops the BERT that is running on one of the lines on the PXM1E UNI/NNI back
card.
lists the changed commands for Release 3.0.10.
Modified Commands for Release 3.0.10
Description
Add a connection on the PXM1E.
Configures certain call control parameters for a specific port.
Lets you configure multiple statistics managers. Index options 1 through 3 are
currently not used (or ignored) by CWM. Index option 4 (Master statistics
manager) was added in release 3.0.10. Use Index option 4 to specify the IP address
of the statistics master for the switch, which defines the IP address of the
workstation authorized to enable or disable statistics on the switch.
Displays priority routing for a nonpersistent endpoint.
Displays priority routing for nonpersistent endpoints.
Displays priority routing.
Displays certain call control parameters for a specific port.
OL-2914-01 Rev D0, July 3, 2003