Table of Contents
Advertisement
General AUSM Provisioning Procedures
Table 2-7
Parameter
-osub
-ipcu
-epcu
-upce
-scrp
-ccdv
-cte
-dis
-pcr01
-scr
-cbs
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
2-18
Parameters for the addcon Command (continued)
Description
Subscription override. To apply CAC, enter -osub 1. To ignore CAC, enter -osub
2. Default setting does not apply CAC.
Ingress percent utilization. Range is 1 to 100 percent. Default setting is 100
percent.
Egress percent utilization. Range is 1 to 100 percent. Default setting is 100
percent.
Usage parameter control (UPC) feature. Enter 1 to disable this feature, or enter 2
to enable UPC.
Note
This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Sustainable Cell Rate (SCR) policing method:
CLP[0] = 1
•
•
CLP[0+1] = 2
No SCR policing = 3
•
This option only applies to the following service class types (-st option):
Note
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Enter the Cell Delay Variation Tolerance (CDVT[0+1]). The range is 1 to 250000
microseconds.
Cell Loss Priority (CLP) tagging feature. Enter 1 to disable this feature, or enter
2 to enable CLP tagging.
This option only applies to the following service class types (-st option):
Note
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Enter the cell discard method:
•
CLP hysteresis = 1
•
Frame based = 2
Peak cell rate for cells with CLP = 0 and CLP = 1. The range depends on the speed
of the logical port:
•
T1 = 10 to 3622
E1 = 10 to 4528
•
Clear E1 = 10 to 4830
•
IMA T1 = 10 to (3591 * number_of_lines)
•
•
IMA E1 = 10 to (4490 * number_of_lines)
•
IMA clear E1 = 10 to (4789 * number_of_lines)
Note
An IMA group's range depends on the number of links in the group.
Multiply the single line rate by the number of lines.
Select the ingress UPC Committed Information Rate (CIR):
Full ATM port rate (T1-3622, E1-4528, clearE1-4830) = 10
•
IMA group rate = ATM port rate x #links
•
Enter the maximum burst size. The range is 1 to 5000 cells.
Chapter 2
Provisioning Communications Links
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Advertisement
Table of Contents
