Cnfchan - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Ausm software
Hide thumbs Also See for MGX 8850 PXM1E:
Table of Contents

Advertisement

Chapter 4
AUSM Command Reference

cnfchan

Configure Channel
Use the cnfchan command to modify a connection that was created with the addcon command.
Syntax
cnfchan <channel_num> <RoutingPriority> <MaxCost> <RestrictTrunkType> <IngrUpcPCR[0+1]>
<MCR> <PctUtil>
Syntax Description
channel_num
RoutingPriority
MaxCost
RestrictTrunkType
IngrUpcPCR[0+1]
MCR
PctUtil
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the channel number of the connection you want to modify. The dspcons
command displays connection channel numbers in the LCN column.
Routing priority for this connection. Range is 1 to 15.
Maximum end-to-end cost for the connection. Range is 1 to 2,147,483,647.
Default setting is 2147483647.
Trunk restriction option. To restrict the connection routing to terrestrial
trunks, enter -type 2. To restrict the connection routing to satellite trunks,
enter -type 3. To enable connection routing without trunk restrictions, enter
-type 1. Default setting routes connections with no restrictions.
Ingress peak cell rate for cells with CLP = 0 and CLP = 1. The range depends
on the speed of the logical port:
T1 = 10 to 3622
E1 = 10 to 4528
Clear E1 = 10 to 4830
IMA T1 = 10 to (3591 * number_of_lines)
IMA E1 = 10 to (4490 * number_of_lines)
IMA clear E1 = 10 to (4789 * number_of_lines)
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Minimum cell rate. The range depends on the speed of the logical port:
T1 = 10 to 3622
E1 = 10 to 4528
Clear E1 = 10 to 4830
IMA T1 = 10 to (3591 * number_of_lines)
IMA E1 = 10 to (4490 * number_of_lines)
IMA clear E1 = 10 to (4789 * number_of_lines)
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Percent utilization. Range is 1 to 100 percent.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
cnfchan
4-55

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8830

Table of Contents