Cnfportq - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

cnfportq

cnfportq
Configure Port Queue
Use the cnfportq command to configure queue parameters for a specified queue on an ATM port or IMA
group.
Syntax
cnfportq <port_num> <q_num> <q_algo> <q_depth> <clp_high> <clp_low> <efci_thres>
Syntax Description
port_num
q_num
q_algo
q_depth
clp_high
clp_low
efci_thres
Related Commands
dspportq, dspportqs
Attributes
Log: Yes
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-74
Enter the port number you want to configure. To list the available ports, enter
the dspports command.
Enter the queue number you want to configure. To list the available queues,
enter the dspportqs command. The queue numbers specify ATM traffic types
as follows:
• 1: CBR (constant bit rate)
2: ABR (available bit rate)
•
• 3: VBR (variable bit rate)
• 4: UBR (unspecified bit rate)
Queue algorithm.
Range: 1–5
0: disable queue
Maximum queue depth.
Range: 1–16000 cells
Cell loss priority (CLP).
Range: 1–16000 cells
Low CLP.
Range: 1–16000 cells
Explicit forward congestion indication (EFCI) threshold.
Range: 1–16000 cells
State: Active Privilege: Strata Group
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002