Table of Contents
Advertisement
Chapter 2
Provisioning Communications Links
Table 2-7
Parameter
-maxcost
-rtngpri
-type
-rpcr
-rscr
-rmcr
-rcbs
Tip
The following addcon command defines a port as the slave side of an SPVC connection. Note the slave
Local Connection ID shown at the end of the display.
PXM1E_SJ.1.4.AUSMB8.a > addcon 1 100 100
Local Connection Id is : 4700918100000000016444445c00000101230100.100.100
PXM1E_SJ.1.4.AUSMB8.a >
Step 3
Write down the NSAP address displayed when the addcon command output is completed. You will need
the NSAP address to configure the master side of the SPVC connection.
Tip
When you set up the master side of the SPVC, you will need to enter the slave ATM address reported by
the addcon command. If you maintain the current session or use the session Copy command to copy the
ATM address now, you can use the session Paste command to complete the addcon command on the
switch that hosts the master side of the SPVC.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Parameters for the addcon Command (continued)
Description
Maximum end-to-end cost for the connection. Range is 1 to 2,147,483,647.
Default setting is 2147483647.
Routing priority for this connection. Range is 1 to 15. Default setting is 8.
Trunk restriction option. To restrict the connection routing to terrestrial trunks,
enter -type 2. To restrict the connection routing to satellite trunks, enter -type 3.
To enable connection routing without trunk restrictions, enter -type 1. Default
setting routes connections with no restrictions.
Remote peak cell rate in cells per second (cps):
•
Full ATM port rate (T1-3622, E1-4528, clearE1-4830) = 10
•
IMA group rate = ATM port rate x #links
Remote sustainable cell rate:
•
Full ATM port rate (T1-3622, E1-4528, clearE1-4830) = 10
IMA group rate = ATM port rate x #links
•
Remote minimum cell rate:
•
Full ATM port rate (T1-3622, E1-4528, clearE1-4830) = 10
•
IMA group rate = ATM port rate x #links
Remote maximum burst size. Range is 1 to 5,000,000.
If you omit one or more of the configuration options when entering the addcon command, the
SPVC connection uses the default values listed in
default value for a given option, enter the option with a desired value.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
General AUSM Provisioning Procedures
Table
2-7, as appropriate. To override the
2-19
Advertisement
Table of Contents
