Table of Contents
Advertisement
Chapter 3
AUSM Card Management
Table 3-3
Parameter
low_vci
high_vci
The following example adds a resource partition to a port after the default partition was deleted.
PXM1E_SJ.1.1.AUSMB8.a > addrscprtn 1 2 100 100 0 255 35 65535 1 1000 1000 2
PXM1E_SJ.1.1.AUSMB8.a >
Several specifications reserve VCI values in the range of 0 through 35. If you are not familiar with these
Tip
specifications and want to avoid potential conflicts, set the lower VCI value to 35.
Modifying a Resource Partition
To modify a resource partition for a port, enter the cnfrscprtn command as follows:
PXM1E_SJ.1.1.AUSMB8.a > cnfrscprtn <port_num> <cntrlr_type> <pct_bw_ingr> <pct_bw_egr>
<low_vpi> <high_vpi> <low_vci> <high_vci> <low_vpid> <high_vpid> <max_lcn> <cntrlr_id>
Table 3-3
The following example changes the default lower VCI value to 35 and leaves all other resource partition
values set to the default values.
PXM1E_SJ.1.1.AUSMB8.a > cnfrscprtn 1 2 100 100 0 255 35 65535 1 1000 1000 2
PXM1E_SJ.1.1.AUSMB8.a >
Several specifications reserve VCI values in the range of 0 through 35. If you are not familiar with these
Tip
specifications and want to avoid potential conflicts, set the lower VCI value to 35.
Deleting a Resource Configuration
To delete the resource partition configuration for a port, use the following procedure.
Step 1
Delete all connections that are associated with the resource partition (dspcons and delcon commands).
Tip
The port number shown in the dspcons display is the resource partition number.
Step 2
Enter the delrscprtn command as follows:
PXM1E_SJ.1.1.AUSMB8.a > delrscprtn <port> <cntrlr_type> <cntrlr_id>
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Parameters for the addrscprtn and cnfrscprtn Commands (continued)
Description
Enter the minimum VCI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 65535.
Enter the maximum VCI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 65535.
lists and describes the parameters for the cnfrscprtn command.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Managing Resource Partitions
3-13
Advertisement
Table of Contents
