Table 2-5 Parameters For Addimagrp Command - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 2 Provisioning Communications Links
by Inverse Multiplexing for ATM (IMA). If this feature is new to you, use the commands with ima in the
command name. If you are accustomed to using the commands with aim in the command name, you can
continue to use these commands.
Table 2-5
Parameter
group_num
port_type
list_of_links
minNumLink
The following example creates an NNI IMA group 1 with lines 1, 2, 3 and 4. The minimum number of
lines is 3.
PXM1E_SJ.1.1.AUSMB8.a > addimagrp 1 2 1.2.3.4 3
Step 4 To verify that the IMA group has been created, enter the dspimagrps command:
PXM1E_SJ.1.1.AUSMB8.a > dspimagrps
List of IMA groups:
===================
ImaGrp PortType Conf
------ -------- ----- -----
1.1
1.2
NextPortNumAvailable:
PXM1E_SJ.1.1.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Parameters for addimagrp Command
Description
Enter a number for the IMA group.
Range: 1–8
Note The AUSM card uses the IMA group number to identify the near and far
ends of the group connection. Use different IMA group IDs at each end
of an IMA connection so that the switch can distinguish between
loopbacked lines (near end IMA group ID) and remote switch
connections.
Specify the port type—1 = UNI, 2 = NN1.
List the links to be included in the group. Separate each link number by a period.
For example, 1.2.3.4 adds links 1 through 4 to the IMA group.
Enter the minimum number of links required for group operation. For example,
if you create an IMA group of 4 lines and specify a minimum number of 3 lines,
then three of the four specified lines must be operational before the IMA group
can be used. The range for this value is from 1 to n, where n represents the
number of lines that are dedicated to the group.
Avail
rate rate
NNI 14364 14364
NNI 14364 0
5
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Lines configured Lines present
--------------- --------------- --------- ----------
1.2.3.4 1.2.3.4
5.6.7.8
General AUSM Provisioning Procedures
Tol Diff Port State
Delay(ms)
275 Active
275 Sig. Failure
2-13