Table of Contents
Advertisement
Related Documentation
Table 3
Cisco MGX 8850 (PXM45) Multiservice Switch Release 3 Documentation (continued)
Title
Cisco SNMP Reference for MGX 8850 (PXM45 and
PXM1E), MGX 8950, and MGX 8830, Release 3
DOC-7814747=
Cisco Frame Relay Software Configuration Guide and
Command Reference for the MGX 8850 FRSM12 Card,
Release 3
DOC-7810327=
Cisco AXSM Software Configuration Guide and
Command Reference for MGX 8850 (PXM45) and MGX
8950, Release 3
DOC-7814257=
Cisco MGX and SES PNNI Network Planning Guide
DOC-7813543=
Cisco MGX Route Processor Module (RPM-XF)
Installation and Configuration Guide, Release 3
OL-2768-01 (online only)
Cisco VISM Installation and Configuration Guide,
Release 3.0
OL-2521-01 (online only)
Regulatory Compliance and Safety Information for the
Cisco MGX 8830, MGX 8850 (PXM45 and PXM1E),
and MGX 8950 Switches
DOC-7814790=
1. CLI = command line interface
2. MIB = Management Information Base
3. SES = Service Expansion Shelf
4. VISM = Voice Interworking Service Module
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
xvi
Description
Provides information on all supported MIB
restrictions, and traps for AXSM, AXSM-E, SRM-3T3, SRME,
FRSM12, PXM45, PXM1E, RPM-PR, and RPM-XF.
Describes how to use the high-speed Frame Relay
(FRSM-12-T3E3) commands that are available in the CLI of the
Cisco MGX 8850 (PXM45) switch.
This guide explains how to configure the AXSM cards for
operation and contains a command reference that describes the
AXSM commands in detail. The AXSM cards covered in this
manual are the AXSM, AXSM/B, AXSM-E, and
AXSM-32-T1E1-E.
Provides guidelines for planning a PNNI network that uses the
Cisco MGX 8850 (PXM45 and PXM1E), Cisco MGX 8950, and
the Cisco BPX 8600 switches. When connected to a PNNI network,
each Cisco BPX 8600 Series Switch requires an SES
route processing.
Describes how to install and configure the Cisco MGX Route
Processor Module (RPM-XF) in the Cisco MGX 8850 Release 3
switch. Also provides site preparation, troubleshooting,
maintenance, cable and connector specifications, and basic Cisco
IOS configuration information.
Describes how to install and configure VISM
MGX 8850 (PXM1), Cisco MGX 8250, and Cisco MGX 8230
switches. Also provides troubleshooting, maintenance, cable and
connector specifications, and Cisco CLI command configuration
information.
Provides regulatory compliance, product warnings, and safety
recommendations for the Cisco MGX 8830, Cisco MGX 8850
(PXM45 and PXM1E), and Cisco MGX 8950 switches.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
About This Book
2
objects, support
3
for PNNI
4
in the Cisco
Advertisement
Table of Contents
