cnfupcrtvbr
scr_mcr
scr_mcr_policing
mbs
IngPcUtil
EgSrvRate
EgPcUtil
clp_tag
Related Commands
dspcon, dspcons
Attributes
Log: Yes
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-86
Select the cell rates to be applied to different classes of service. This parameter
sets the Sustainable Cell Rate (SCR) to be used for VBR traffic and the
Minimum Cell Rate (MCR) to be used for standard ABR traffic.
The range is: 10 to pcr[0+1]. To retain the current value, enter 0.
Set to one of the following values:
•
1: CLP[0] Cells
•
2: CLP[0+1] Cells
•
3: No SCR/MCR Policing
Enter the maximum burst size. The range is 1 to 5000 cells.
Ingress percentage utilization.
Range: 1–127
Egress service rate. The range depends on the speed of the logical port:
•
T1 = 10 to 3622
•
E1 = 10 to 4528
Clear E1 = 10 to 4830
•
•
IMA T1 = 10 to (3591 * number_of_lines)
IMA E1 = 10 to (4490 * number_of_lines)
•
IMA clear E1 = 10 to (4789 * number_of_lines)
•
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Egress percentage utilization.
Range: 1–127
Cell Loss Priority (CLP) tagging feature. Enter 1 to disable this feature, or enter
2 to enable CLP tagging.
Note
This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
State: Active
Privilege: Group 2
Chapter 4
AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002