Rrtcon - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 4 AUSM Command Reference

rrtcon

Reroute Connection
Use the rrtcon command to reroute a connection between two different switches.
Note This command operates only on master endpoints and on connections between two different switches.
This command does not reroute DAX connections, which are connections between two interfaces on the
same switch.
Syntax
rrtcon <port_num.vpi.vci | channel_num>
Syntax Description
port_num
vpi
vci
channel_num
Related Commands
dncon, upcon
Attributes
Log: Yes
Example
Reroute the connection using LCN 19.
PXM1E_SJ.1.4.AUSMB8.a > rrtcon 19
PXM1E_SJ.1.4.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the port number for the connection you want to modify. To display a list
of configured ports, enter the dspports command. To display a complete list of
connections, enter the dspcons command.
Enter the VPI of the connection you want to display. The VPI for a connection
is displayed in the dspcons command report.
Enter the VCI of the connection you want to display. The VCI for a connection
is displayed in the dspcons command report.
Enter the channel number of the connection you want to modify. The dspcons
command displays connection channel numbers in the LCN column.
State: Active
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 1
rrtcon
4-183