Dspplpp - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

dspplpp

dspplpp
Display PLPP
Use the dspplpp command to view the configured Physical Layer Protocol Process (PLPP) parameters
for a line on the current AUSM.
Syntax
dspplpp <phy_port_num>
Syntax Description
phy_port_num
Related Commands
cnfplpp
Attributes
Log: Yes
Example
Display PLPP parameters for line 8 on the current AUSM card.
PXM1E_SJ.1.21.AUSMB8.a > dspplpp 8
PhysicalPortNumber:
CellFraming:
CellScramble:
Plpp Loopback:
Single-bit error correction:
PXM1E_SJ.1.21.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-158
Line number for which you want to configure PLPP. Use the dsplns command
to view the available lines.
The help for the cnfplpp command refers to a physical port, which is
Note
the same thing as a line. A logical port is the entity that is created with
the addport command.
State: Active Privilege: 1
8
ATM
No Scramble
No Loopback
Enabled
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002