Cnfcon - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

cnfcon

cnfcon
Configure Connection
Use the cnfcon command to modify a connection that was created with the addcon command.
Syntax
cnfcon <port_num.vpi.vci> <RoutingPriority> <MaxCost> <RestrictTrunkType> <IngrUpcPCR[0+1]>
<MCR> <PctUtil>
Syntax Description
port_num
vpi
vci
RoutingPriority
MaxCost
RestrictTrunkType
IngrUpcPCR[0+1]
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-58
Enter the port number for the connection you want to test. To display a list of
configured ports, enter the dspports command. To display a complete list of
connections, enter the dspcons command.
Enter the VPI of the connection you want to display. The VPI for a connection
is displayed in the dspcons command report.
Enter the VCI of the connection you want to display. The VCI for a connection
is displayed in the dspcons command report.
Routing priority for this connection. Range is 1 to 15.
Maximum end-to-end cost for the connection. Range is 1 to 2,147,483,647.
Default setting is 2147483647.
• Trunk restriction option. To restrict the connection routing to terrestrial
trunks, enter -type 2. To restrict the connection routing to satellite trunks,
enter -type 3. To enable connection routing without trunk restrictions, enter
-type 1. Default setting routes connections with no restrictions.
Ingress peak cell rate for cells with CLP = 0 and CLP = 1. The range depends
on the speed of the logical port:
T1 = 10 to 3622
•
• E1 = 10 to 4528
• Clear E1 = 10 to 4830
IMA T1 = 10 to (3591 * number_of_lines)
•
IMA E1 = 10 to (4490 * number_of_lines)
•
IMA clear E1 = 10 to (4789 * number_of_lines)
•
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002