Managing Cards; Determining The Card Feature Set - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Managing Cards

Table 3-1
Command
myid
setcmdc
setpagemode
Managing Cards
Basic card initialization and configuration is described in the Cisco MGX 8850 (PXM1E) and MGX
883Cisco MGX 8850 (PXM1E) and MGX 8830 Software Configuration Guide, Release 3. The following
sections provide procedures for doing the following:
•
•
•
This section provides procedures for some of the most common card management commands. For a
Note
complete list of card management commands, refer to
Reference."

Determining the Card Feature Set

The AUSM-8T1/B and AUSM-8E1/B cards can support ABR Rate Control and Inverse Multiplexing
over ATM (IMA). To display the state of these feature options, enter the dspfeature command as shown
in the following example:
PXM1E_SJ.1.21.AUSMB8.a > dspfeature
Rate Control:
IMA feature:
PXM1E_SJ.1.21.AUSMB8.a >
The example above is for an AUSM-8T1/B card. To determine whether the card is an AUSM-8T1/B or
an AUSM-8E1/B, use the dspcd or dspcds command.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
3-2
Session Management Commands (continued)
Description
Displays the user ID that was used to start the current session.
Enables or disables the command completion feature, which automatically
completes an incomplete command if the command portion entered uniquely
identifies a supported command.
Enables or disables the page feature, which breaks command displays into pages
for easier viewing.
Determining the Card Feature Set
Displaying General Card Information
Displaying Software Version and Status Information
On
On
Chapter 3
Table 4-2 in Chapter 4, "AUSM Command
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
AUSM Card Management