Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference page 156

cnfupcabr
scr_mcr_police
mbs
IngPcUtil
EgSrvRate
EgPcUtil
clp_tag
Related Commands
cnfconstdabr, dspcon, dspcons, dspconstdabr
Attributes
Log: Yes
Example
The following example configures UPC ABR parameters.
PXM1E_SJ.1.13.AUSMB8.a > cnfupcabr 16 2 3622 10000 0 1 1024 100 3622 100 2
PXM1E_SJ.1.13.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-82
Sustainable Cell Rate (SCR) policing method:
• CLP[0] = 1
CLP[0+1] = 2
•
• No SCR policing = 3
Note This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Enter the maximum burst size. The range is 1 to 5000 cells.
Ingress percentage utilization.
Range: 1–127
Egress service rate. The range depends on the speed of the logical port:
T1 = 10 to 3622
•
• E1 = 10 to 4528
• Clear E1 = 10 to 4830
IMA T1 = 10 to (3591 * number_of_lines)
•
IMA E1 = 10 to (4490 * number_of_lines)
•
IMA clear E1 = 10 to (4789 * number_of_lines)
•
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Egress percentage utilization.
Range: 1–127
Cell Loss Priority (CLP) tagging feature. Enter 1 to disable this feature, or enter
2 to enable CLP tagging.
Note This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
State: Active Privilege: Group 2
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002