Addimagrp - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 4 AUSM Command Reference

addimagrp

Add IMA Group
Use the addimagrp command to group up to 8 lines for operation as a single, logical ATM path with
higher throughput.
Syntax
addimagrp <group_num> <port_type> <list_of_links> <minNumLink>
Syntax Description
group_num
port_type
list_of_links
minNumLink
Related Commands
addlns2imagrp, cnfimagrp, delimagrp, dellnsfmimagrp, dspimagrp, dspimagrps
Attributes
Log: Yes
Example
The following example creates an NNI IMA group 1 with lines 1, 2, 3 and 4. The minimum number of
lines is 3.
PXM1E_SJ.1.1.AUSMB8.a > addimagrp 1 2 1.2.3.4 3
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter a number for the IMA group.
Range: 1–8
Note The AUSM card uses the IMA group number to identify the near and far
ends of the group connection. Use different IMA group IDs at each end
of an IMA connection so that the switch can distinguish between
loopbacked lines (near end IMA group ID) and remote switch
connections.
Specify the port type—1 = UNI, 2 = NN1.
List the links to be included in the group. Separate each link number by a period.
For example, 1.2.3.4 adds links 1 through 4 to the IMA group.
Enter the minimum number of links required for group operation. For example,
if you create an IMA group of 4 lines and specify a minimum number of 3 lines,
then three of the four specified lines must be operational before the IMA group
can be used. The range for this value is from 1 to n, where n represents the
number of lines that are dedicated to the group.
State: Active
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 1
addimagrp
4-15