Line Configuration Quickstart; Atm Port Configuration Quickstart - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Ausm software
Hide thumbs Also See for MGX 8850 PXM1E:
Table of Contents

Advertisement

Chapter 2
Provisioning Communications Links

Line Configuration Quickstart

To prepare AUSM lines for communications with customer premises equipment (CPE), perform the
following steps:
Command
Step 1
username
<password>
Step 2
addln <line>
Related commands:
dsplns
dspln <line>
delln <line>
Step 3
cnfln <options>
Related commands:
dsplns
dspln <line>
delln <line>

ATM Port Configuration Quickstart

An ATM port is a logical entity that adds ATM layer communications to a physical line that connects an
MGX 8850 switch to a CPE ATM device (which, in most cases, is a router).
Note
The equipment at both ends of an ATM line must be configured with compatible settings in order for the
link to be logically completed.
To configure an ATM port on an AUSM card, perform the following steps:
Command
Step 1
username
<password>
Step 2
addln <line>
Step 3
addport <options>
Related commands:
dspport <port>
dspports
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Purpose
Start a configuration session.
Note
To perform the steps in this quickstart procedure, you
must log in as a user with GROUP1 privileges or higher.
Bring up a line.
This step establishes physical layer connectivity between an
MGX switch and an ATM device.
See the
"Bringing Up Lines"
chapter.
This optional step allows you to change a line configuration when
the default or existing configuration needs changing.
See the
"Configuring Lines"
chapter.
Purpose
Start a configuration session.
Note
To perform all the steps in this quickstart procedure, you
must log in as a user with GROUP1 privileges or higher.
Prepare an AUSM line for communications.
See
"Line Configuration
Quickstart," which appears earlier in
this chapter.
Add an ATM port.
This step establishes ATM communications between two ATM
devices.
See the
"Adding ATM Ports"
chapter.
Quickstart Provisioning Procedures
section that appears later in this
section that appears later in this
section that appears later in this
2-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8830

Table of Contents