Displaying The Status Of A Single Port - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 3 AUSM Card Management
List of IMA groups:
===================
ImaGrp PortType Conf
------ -------- ----- -----
1.1
NextPortNumAvailable:
ImaGrp
------
1.1
Syntax : dspports
PXM1E_SJ.1.1.AUSMB8.a >
The port list is divided into two lists, one of ATM ports and one for IMA groups (which are ATM ports
using multiple lines). To determine if a port is in alarm, check the status in the Port State column. For
more information on a single port, use the dspport command.

Displaying the Status of a Single Port

To display the configuration and status of a single port, enter the dspport command as follows:
PXM1E_SJ.1.1.AUSMB8.a > dspport <port>
Enter the port number with the command. You can view the port numbers in the dspports display. The
following example shows the dspport display for ATM port 8.
PXM1E_SJ.1.1.AUSMB8.a > dspport 8
LogicalPortNumber:
Port Enable:
Port State:
PortType:
PhysicalPortNumber:
CellFraming:
CellScramble:
Plpp Loopback:
Single-bit error correction:
PXM1E_SJ.1.1.AUSMB8.a >
The next example shows the report for an ATM port number that is assigned to an IMA group. This is
the same report that appears when you enter the dspimagrp command.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Avail
rate rate
NNI 14364 14364
4
Sync State
----------
Far-End Permanent
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Lines configured Lines present
--------------- --------------- --------- ----------
1.2.3.4 1.2.3.4
8
UP
Line alarm
UNI
8
ATM
No Scramble
No Loopback
Disabled
Managing Ports
Tol Diff Port State
Delay(ms)
275 Active
3-7