Cnflnloop - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

cnflnloop

cnflnloop
Configure Line Loop
Use the cnflnloop command to enable or disable code detection when the specified line is placed in
loopback mode.
Use the dspln command to display the configuration for loopback mode.
Tip
Syntax
cnflnloop <line_num> <lpbkCodeDetection>
Syntax Description
line_num
lpbkCodeDetection
Related Commands
addlnloop, dellnloop, dspln, dsplns
Attributes
Log: Yes
Example
Enable code detection for line 8 in loopback mode.
PXM1E_SJ.1.21.AUSMB8.a > cnflnloop 8 2
PXM1E_SJ.1.21.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-72
Line number for which you want to configure code detection. Use the dsplns
command to view the available lines.
Loopback code detection parameter. Enter 1 to disable code detection or 2 to
enable code detection.
State: Active Privilege: Service Group
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002