Managing Ports
Enter the line number with the command. You can view the available line numbers in the dsplns display.
The following example shows how to use the delln command:
PXM1E_SJ.1.21.AUSMB8.a > delln 8
PXM1E_SJ.1.21.AUSMB8.a >
Managing Line Alarms
The switch generates line alarms when problems occur. Use the following commands to display these
alarms and alarm configuration parameters:
•
•
•
•
Use the following commands to clear alarms and alarm counts on lines:
•
•
•
•
Managing Ports
Chapter 2, "Provisioning Communications Links,"
AUSM cards. The following sections provide procedures for doing the following:
•
•
•
Displaying a List of Ports
To display a list of ports on the current AUSM card, enter the dspports command as follows:
PXM1E_SJ.1.1.AUSMB8.a > dspports
List of ATM ports:
==================
Port PortType Line# Portenable
---- -------- ----- ----------
1.5
1.6
1.7
1.8
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
3-6
dspalm
dspalmcnf
dspalmcnt
dspalms
clralm
clralmcnt
clralmcnts
clralms
Displaying a List of Ports
Displaying the Status of a Single Port
Deleting Ports
NNI
5
UP
NNI
6
UP
UNI
7
UP
UNI
8
UP
describes how to add logical ports to the lines on
Speed
PortState
-----
---------
3622
Line alarm
3622
Line alarm
3622
Line alarm
3622
Line alarm
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Chapter 3
AUSM Card Management