Cnfchanq - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 4 AUSM Command Reference

cnfchanq

Configure Channel Queue
Use the cnfchanq command to configure queue management parameters for a specific connection.
Syntax
cnfchanq <port_num.vpi.vci> <discard_option> <vc_q_depth> <clp_thresh_high>
<clp_thresh_low/epd_threshold> <efci_thresh>
Syntax Description
port_num
vpi
vci
discard_option
vc_q_depth
clp_thresh_high
clp_thresh_low
or
epd_threshold
efci_thresh
Related Commands
addcon, cnfcon, delcon, dncon, dspcon, dspcons, rrtcon, tstdelay, upcon
Attributes
Log: Yes
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the port number for the connection you want to test. To display a list of
configured ports, enter the dspports command. To display a complete list of
connections, enter the dspcons command.
Enter the VPI of the connection you want to display. The VPI for a connection
is displayed in the dspcons command report.
Enter the VCI of the connection you want to display. The VCI for a connection
is displayed in the dspcons command report.
The discard option: 1 for CLP hysteresis or 2 for F = frame-based.
Ingress queue depth.
Range: 1–16000 cells
CLP high threshold.
Range: 1–16000 cells
CLP low threshold for CLP hysteresis-based discard.
Range: 1–16000 cells
EPD threshold Frame-based discard.
Range: 1–16000 cells
EFCI threshold.
Range: 1–16000 cells
State: Active
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 2
cnfchanq
4-57