Table of Contents
Advertisement
Chapter 3
AUSM Card Management
Managing IMA Groups
Chapter 2, "Provisioning Communications Links,"
The following sections provide procedures for doing the following:
•
•
•
•
•
Note
This section provides procedures for some of the most common line management commands. For a
complete list of line management commands, refer to
Reference."
Displaying a List of IMA Groups
To display a list of IMA groups on the current AUSM card, enter the dspimagrps command as follows:
PXM1E_SJ.1.1.AUSMB8.a > dspimagrps
List of IMA groups:
===================
ImaGrp PortType Conf
------ -------- ----- -----
1.1
1.2
NextPortNumAvailable:
PXM1E_SJ.1.1.AUSMB8.a >
Displaying the Configuration for a Single IMA Group
To display the configuration of a single IMA group, enter the dspimagrp command as follows:
PXM1E_SJ.1.21.AUSMB8.a > dspimagrp <group_num>
Enter the group number with the command. You can view the available group numbers in the
dspimagrps display. The following example shows the information you can display with the dspimagrp
command:
PXM1E_SJ.1.1.AUSMB8.a > dspimagrp 1
IMA Group number
Port type
Lines configured
Enable
IMA Port state
IMA Group Ne state
PortSpeed (cells/sec)
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Displaying a List of IMA Groups
Displaying the Configuration for a Single IMA Group
Adding Lines to an IMA Group
Deleting Lines from an IMA Group
Deleting an IMA Group
Avail
rate
rate
NNI
14364 14364
NNI
14364
0
5
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
describes how to create and configure IMA groups.
Table 4-5
Lines configured
Lines present
---------------
--------------- --------- ----------
1.2.3.4
1.2.3.4
5.6.7.8
: 1
: NNI
: 1.2.3.4
: Enabled
: Active
: operational
: 14364
Managing IMA Groups
in
Chapter 4, "AUSM Command
Tol Diff
Port State
Delay(ms)
275
Active
275
Sig. Failure
3-9
Advertisement
Table of Contents
