Configuring Lines - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

General AUSM Provisioning Procedures
Step 4 To display the current configuration for all lines on an AUSM card, enter the dsplns command:
PXM1E_SJ.1.5.AUSMB8.a > dsplns
Line
----
5.1
5.2
5.3
5.4
5.5
5.6
5.7
5.8
LineNumOfValidEntries: 8
PXM1E_SJ.1.5.AUSMB8.a >
When a line has been successfully brought up, the status column reports the line status as Ena, which is
an abbreviation for enabled.
The alarm state indicates whether the line is communicating with a remote switch. When the alarm state
is blank or is reported as No, it indicates that the physical devices at each end of the line have established
physical layer communications. Higher-layer connectivity is established later when ports are configured
on the AUSM card lines.

Configuring Lines

All line types are brought up with a default configuration, which may or may not be compatible with the
ATM device to which you are connecting. When configuring an AUSM card line, you must ensure that
the devices at both ends of the connection are using the same configuration parameters on the shared line.
To configure lines on an AUSM card, perform the following steps:
Step 1 Establish a configuration session using a user name with GROUP 1 privileges or higher.
If you do not know the line number you want to configure on the AUSM card, enter the dsplns command
Step 2
to display the current configuration of all lines on the card:
PXM1E_SJ.1.5.AUSMB8.a > dsplns
Remember that you cannot configure a line until you have brought it up, as described earlier in the
"Bringing Up Lines"
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
2-8
Conn Type Status/Coding
Type
----- ------------ ------ -------- ------------- -------- ----- -----
RJ-48 dsx1ESF Ena/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Mod/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Mod/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Mod/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Dis/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Dis/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Dis/dsx1B8ZS 0-131 ft
RJ-48 dsx1ESF Ena/dsx1B8ZS 0-131 ft
section.
Chapter 2 Provisioning Communications Links
Length XmtClock Alarm Stats
Source
LocalTim No
LocalTim Yes
LocalTim Yes
LocalTim Yes
LocalTim
LocalTim
LocalTim
LocalTim Yes
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Alarm
No
Yes
Yes
Yes
Yes