Adding Lines To An Ima Group; Deleting Lines From An Ima Group; Table 3-2 Parameters For Addlns2Imagrp And Dellnsfmimagrp Commands - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Managing IMA Groups
GroupTxAvailCellRate (cells/sec) : 14364
ImaGroupTxFrameLength(cells)
LcpDelayTolerance (IMA frames)
ReadPtrWrPtrDiff
Minimum number of links
MaxTolerableDiffDelay (msec)
Lines Present
Observed Diff delay (msec)
Clock Mode
GroupAlpha
GroupBeta
GroupGamma
GroupConfiguration
IMAGrp Failure status
Timing reference link
ImaGroupTxImaId
ExpectedGroupRxImaId
PXM1E_SJ.1.1.AUSMB8.a >

Adding Lines to an IMA Group

To add one or more lines to an IMA group, use the addlns2imagrp command as follows:
PXM1E_SJ.1.1.AUSMB8.a > addlns2imagrp <group_num> <list_of_lines>
Table 3-2
Table 3-2
Parameter
group_num
list_of_lines
The following example shows how to add a single line to an IMA group.
PXM1E_SJ.1.1.AUSMB8.a > addlns2imagrp 1 8
PXM1E_SJ.1.1.AUSMB8.a >
The next example shows how to add multiple lines to an IMA group.
PXM1E_SJ.1.1.AUSMB8.a > addlns2imagrp 1 7.8
PXM1E_SJ.1.1.AUSMB8.a >

Deleting Lines from an IMA Group

To delete one or more lines from an IMA group, enter the dellnsfmimagrp command as follows:
PXM1E_SJ.1.1.AUSMB8.a > dellnsfmimagrp <group_num> <list_of_lines>
Table 3-2
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
3-10
(cells)
describes the parameters for this command.
Parameters for addlns2imagrp and dellnsfmimagrp Commands
Description
Enter the number for the IMA group you want to modify. Use the dspimagrps
command to display the configured IMA groups.
List the lines to be included in the group. Separate each line number by a period.
For example, 1.2.3.4 adds lines 1 through 4 to the IMA group.
describes the parameters for this command.
: 128
: 1
: 4
: 3
: 275
: 1.2.3.4
: 0
: CTC
: 2
: 2
: 1
: 1
: No Failure
: 1
: 0x0
: 0x0
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Chapter 3 AUSM Card Management