Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference page 164

cnfupcvbr
scr_mcr_policing
mbs
IngPcUtil
EgSrvRate
EgPcUtil
clp_tag
Related Commands
dspcon, dspcons
Attributes
Log: Yes
Example
Configure the channel bandwidth control parameters for a variable bit rate (VBR) connection type on
the current AUSM.
s1.1.12.AUSMB8.a > cnfupcvbr 2.1.3 2 3000 250000 2000 1 1000 50 4000 50 2
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-90
Set to one of the following values:
• 1: CLP[0] Cells
2: CLP[0+1] Cells
•
• 3: No SCR/MCR Policing
Enter the maximum burst size. The range is 1 to 5000 cells.
Ingress percentage utilization.
Range: 1–127
Egress service rate. The range depends on the speed of the logical port:
T1 = 10 to 3622
•
• E1 = 10 to 4528
• Clear E1 = 10 to 4830
IMA T1 = 10 to (3591 * number_of_lines)
•
IMA E1 = 10 to (4490 * number_of_lines)
•
IMA clear E1 = 10 to (4789 * number_of_lines)
•
Note An IMA group's range depends on the number of links in the group.
Multiply the single line rate by the number of lines.
Egress percentage utilization.
Range: 1–127
Cell Loss Priority (CLP) tagging feature. Enter 1 to disable this feature, or enter
2 to enable CLP tagging.
Note This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
State: Active Privilege: Group 2
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002