Table of Contents
Advertisement
Chapter 4
AUSM Command Reference
delchanloop
Delete Channel Loopback
Use the delchanloop command to delete a channel loopback from the current AUSM.
Syntax
delchanloop <port_num.vpi.vci | channel_num>
Syntax Description
port_num
vpi
vci
channel_num
Related Commands
addchanloop, dspcon, dspcons, tstcon, tstdelay
Tip
To view the loopback status of a connection, use the dspcon command and look for the line labeled
LocalRemoteLpbkState.
Attributes
Log: No
Example
Remove channel loopback from channel 16 on the current AUSM card.
PXM1E_SJ.1.4.AUSMB8.a > delchanloop 16
PXM1E_SJ.1.4.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the port number for the connection you want to modify. To display a list
of configured ports, enter the dspports command. To display a complete list of
connections, enter the dspcons command.
Enter the VPI of the connection you want to display. The VPI for a connection
is displayed in the dspcons command report.
Enter the VCI of the connection you want to display. The VCI for a connection
is displayed in the dspcons command report.
Enter the channel number of the connection you want to modify. The dspcons
command displays connection channel numbers in the LCN column.
State: Active
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 4
delchanloop
4-95
Advertisement
Table of Contents
