Table of Contents
Advertisement
dspconstdabr
dspconstdabr
Display Connection Standard ABR
Use the dspconstdabr command to display the Standard ABR configuration on a connection.
Syntax
dspconstdabr <port_num.vpi.vci | channel_num>
Syntax Description
port_num
vpi
vci
channel_num
Related Commands
addcon, cnfconabrparams, cnfconabrrates, cnfconstdabr, dspcon, dspcons
Attributes
Log: No
Example
Display the ABR parameter configuration on connection 16.
PXM1E_SJ.1.13.AUSMB8.a > dspconstdabr 16
PXM1E_SJ.1.13.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-138
Enter the port number for the connection you want to display. To display a list
of configured ports, enter the dspports command. To display a complete list of
connections, enter the dspcons command.
Enter the VPI of the connection you want to display. The VPI for a connection
is displayed in the dspcons command report.
Enter the VCI of the connection you want to display. The VCI for a connection
is displayed in the dspcons command report.
Enter the channel number of the connection you want to display. The dspcons
command displays connection channel numbers in the LCN column.
State: Active
ChannelNumber
Minimum Cell Rate
Peak Cell Rate
Initial Cell rate
Rate Increase Factor
Rate Decrease Factor
Nrm -- Inrate Cell Count
Trm -- Time limit for Frm
Transient Buffer Exposure
Fixed Round Trip Time
ACR Decrease Time Factor
Cutoff Decrease Factor
ABRType
Privilege: Any User
:
16
:
10 Cells per second
:
3622 Cells per second
:
3622 Cells per second
:
64
:
16
:
64
:
255 milliseconds
:
16777215 Cells
:
0 milliseconds
:
500 milliseconds
:
16
:
Switch behavior without VS/VD
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Chapter 4
AUSM Command Reference
Advertisement
Table of Contents
