Displaying General Card Information; Displaying Software Version And Status Information - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 3 AUSM Card Management

Displaying General Card Information

To display general information about an AUSM card, use the dspcd command as shown in the following
example:
PXM1E_SJ.1.21.AUSMB8.a > dspcd
ModuleSlotNumber:
FunctionModuleState:
FunctionModuleType:
FunctionModuleSerialNum:
FunctionModuleHWRev:
FunctionModuleFWRev:
FunctionModuleResetReason: Reset by PXM
LineModuleType:
LineModuleState:
mibVersionNumber:
configChangeTypeBitMap:
cardIntegratedAlarm:
cardMajorAlarmBitMap:
cardMinorAlarmBitMap:
Type <CR> to continue, Q<CR> to stop:
Hardware Revision
Card Type
Serial Number
Fab Number
Hardware Revision
Card Type
Serial Number
Fab Number
PXM1E_SJ.1.21.AUSMB8.a >
Note that the dspcd command displays information on card alarms.

Displaying Software Version and Status Information

To display information on the software running on a AUSM card, use the chkflash and version
commands.
The chkflash command shows the status of the boot software:
PXM1E_SJ.1.21.AUSMB8.a > chkflash
Program length = 377836
Calculated checksum = 3818c59a stored checksum = 3818c59a
Flash checksum passed
PXM1E_SJ.1.21.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Front Card Info
:
:
:
:
Back Card Info
:
:
:
:
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
21
Active
AUSM-8T1/B
820581
ae
020.000.001.000-D
LM-RJ48-8T1
Present
80
CardCnfChng, LineCnfChng
Major
Line Alarm
ATM PORT ALARM
Channel failure
AE
52
820581
28-2160-01
AA
22
773224
28-2011-01
Managing Cards
3-3