Table of Contents
Advertisement
Chapter 3
AUSM Card Management
Deleting a line from an IMA group reduces the available throughput for the group and may impact ATM
Note
traffic through the group. Also, the switch does not allow you to delete lines when the resulting number
of lines would be less than the minimum number of lines specified for group operation. To change the
minimum number of lines for an IMA group, use the cnfimagrp command.
The following example shows how to delete a single line from an IMA group.
PXM1E_SJ.1.1.AUSMB8.a > dellnsfmimagrp 1 8
Warning: If Connections exist under the ima group then the cell rates might require
modification
PXM1E_SJ.1.1.AUSMB8.a >
The next example shows how to delete multiple lines from an IMA group.
PXM1E_SJ.1.1.AUSMB8.a > dellnsfmimagrp 1 7.8
Warning: If Connections exist under the ima group then the cell rates might require
modification
PXM1E_SJ.1.1.AUSMB8.a >
Deleting an IMA Group
To delete an IMA group, use the following procedure.
Step 1
Delete all connections that are associated with the IMA group (dspcons and delcon commands).
The port number shown in the dspcons display is the IMA group number.
Tip
Step 2
Delete all resource partitions that are associated with the IMA group (delrscprtn command).
Enter the delimagrp command as follows:
Step 3
PXM1E_SJ.1.21.AUSMB8.a > delimagrp <group_num>
Enter the group number with the command. You can view the available group numbers in the
dspimagrps display. The following example shows how to use the delimagrp command:
PXM1E_SJ.1.1.AUSMB8.a > delimagrp 1
PXM1E_SJ.1.1.AUSMB8.a >
Managing Resource Partitions
Resource partitions define how port resources are distributed between two or more controllers. This
software release supports only the PNNI controller, so all port resources are assigned to PNNI when a
port or IMA group is added. This resource assignment is automatically made by the software and results
in the creation of a resource partition for the port.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Managing Resource Partitions
3-11
Advertisement
Table of Contents
