Cnfportrscprtn - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

cnfportrscprtn

cnfportrscprtn
Configure Port Resource Partition
A resource partition assigns port resources such as bandwidth and a VPI and VCI range to a specific
controller such as PNNI. In this release, a PNNI resource partition is automatically created when an ATM
port or IMA group is created, and all resources are assigned to the PNNI controller. Use the
cnfportrscprtn command to modify a resource partition after you have created an ATM port or an IMA
group.
Syntax
cnfportrscprtn <port_num> <cntrlr_type> <pct_bw> <low_vpi> <high_vpi> <low_vci> <high_vci>
<low_vpid> <high_vpid> <max_lcn> <cntrlr_id>
Syntax Description
port_num
cntrlr_type
pct_bw
low_vpi
high_vpi
low_vci
high_vci
low_vpid
high_vpid
max_lcn
Related Commands
addrscprtn, delrscprtn, dspportrscprtn, dsprscprtn
Attributes
Log: Yes
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-76
Port number to be partitioned. You must add a port to a line before you can
define a partition for a port. Use the dspports command to view the available
ports.
Controller for this partition. Enter PNNI as the PNNI controller is the only
controller type supported in this release.
Bandwidth percentage. Enter the percentage of the line bandwidth to be used by
this controller for communications. Range is 1 to 100 percent.
Enter the minimum VPI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 255.
Enter the maximum VPI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 255.
Enter the minimum VCI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 65535.
Enter the maximum VCI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 65535.
Enter the minimum virtual path identification number to allow for connections
using the specified controller type (cntrlr_type) on this port. The range is from
1 to 1000.
Enter the maximum virtual path identification number to allow for connections
using the specified controller type (cntrlr_type) on this port. The range is from
1 to 1000.
Maximum LCN to be used on this port. Range is 1 to 1000.
State: Active Privilege: Group 1
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002