Chapter 1
Configuring Smart Call Home
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# callhome
Step 3
switch(config-callhome)#
destination-profile name alert-group
{All | Configuration |Diagnostic | EEM |
Cisco-TAC | Environmental | Inventory |
License | Linecard-Hardware |
Supervisor-Hardware | Syslog-group-port
| System | Crash | Test}
Step 4
switch(config-callhome)# show callhome
destination-profile [profile name]
Step 5
switch(config)# copy running-config
startup-config
This example shows how to associate all alert groups with the destination profile Noc101:
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# destination-profile Noc101 alert-group All
Adding show Commands to an Alert Group
To assign a maximum of five user-defined CLI show commands to an alert group, perform this task:
You cannot add user-defined CLI show commands to the CiscoTAC-1 destination profile.
Note
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# callhome
Step 3
switch(config-callhome)# alert-group
{Configuration | Diagnostic |
Environmental | Inventory | License |
Linecard-Hardware | Supervisor-Hardware
| Syslog-group-port | System | Test}
user-def-cmd show-cmd
OL-16597-01
Purpose
Enters configuration mode.
Enters callhome configuration mode.
Associates an alert group with this destination profile.
Use the All keyword to associate all alert groups with
the destination profile.
(Optional) Displays information about one or more
destination profiles.
(Optional) Saves this configuration change.
Purpose
Enters configuration mode.
Enters callhome configuration mode.
Adds the show command output to any Call Home
messages sent for this alert group. You must enclose
the show command in double quotes. Only valid show
commands are accepted.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring Call Home
1-11