Managing The Switch; Displaying Information About Installed Hardware Modules - Cisco Nexus 7710 Site Preparation And Hardware Installation Manual

Managing the Switch

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Displaying Information About Installed Hardware Modules

To display information about the switch hardware and the hardware modules installed in the switch chassis,
use the show hardware command.
Enter the show hardware command.
Example:
show hardware
switch#
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Documents: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_seri
es_home.html
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained in this software are
owned by other third parties and used and distributed under
license. Certain components of this software are licensed under
the GNU General Public License (GPL) version 2.0 or the GNU
Lesser General Public License (LGPL) Version 2.1. A copy of each
such license is available at
OL-30452-01.
Displaying Information About Installed Hardware Modules, on page 49
Displaying the Hardware Inventory for a Switch, on page 52
Displaying the Backplane and Serial Number Information, on page 52
Displaying Environmental Information for a Switch, on page 53
Displaying Temperatures for Modules, on page 57
Connecting to a Module, on page 59
Saving the Module Configuration, on page 60
Displaying Power Usage Information, on page 60
Reloading a Module, on page 60
Rebooting the Switch, on page 61
Overview of Supervisor Modules, on page 62
Overview of I/O Module Support, on page 63
Overview of Fabric Module Support, on page 69
Power Modes Overview, on page 71
Overview of Fan Trays, on page 82
Cisco Nexus 7710 Switch Site Preparation and Hardware Installation Guide
5
C H A P T E R
49